Видео

Anyone gets a hole in pool, use flex tape, you can go under water with it & tape the hole.

Would the pump work without a filter in it? I was trying out mine and it wasn't generating pressure.

Most likely the concrete blocks is what caused the tear.

😂

My white plastic screw is not there. After market canisters. 😵‍💫

should of cleaned it out before filling with water then u wouldn't have all the extra work

Buring your brick blocks so they are level with ground Get a felt pool pad 20-30$ to go on top of sand If ya get a leak, get some waterproof gorilla tape, works under water so no need to drain pool

Messiah’s name is Yeshua.

Well why would you splash by getting in the pool😅

For everyone saying his mistake was putting it on bricks you are incorrect his mistake was not burying the bricks and making it level with the rest of the ground

Can you provide the link to the t body I need one to

A man in his garage is doing a better engineering job than the cub cadet engineers did.

Yes even with steel cable u always leave a few wraps not fully out

That spring keeps tension on the spool so it don’t just spool out like a broken spring lol it’s a spool guild and to keep tension on spool Bottom mine u won’t need worry it’s on a lawn mower it’ll pull it out with shoe string .

You’ll hate it ! Ima avid rock crawler and there nothing like the bang of a steel cable when your really stuck . I’ll never go synthetic man.

Thank you for making this video. I replaced my motor and linkage as it was seized. However now my wipers always park in the middle of the windshield instead of at the bottom. I even tried letting the motor home itself, then bolt the wipers back on at the base of windshield. Turn them on, and they park in middle again when I turn them off. I even took out the linkage, manually pushed it to the parked position, re-installed and turned car on, let wipers run, no issues. Turn them off and they park in middle of windshield again. This wouldn't be a fuse or relay right? Any ideas?

Thanks for the video. I look forward to seeing your orange messiah in jail.

The brick blocks are cutting your liner. This pool moves.

You’re cracking me up because you talk just like me. Thanks for the video

Put it right on top of sand including pole base. I have the same set up

Did you have to upgrade your pump brother or did it come with that one? If so, where did you get it?

Try digging the dirt out for your pavers and making them level with the ground. I would also recommend putting landscaping fabric around your pool and then cover with rock. That should help with reducing erosion around your pool.

The old style Braun, they sure don't build shit like back in the oldschool days, thanks for the heads up pal, harbor freight reminds me of weekends at the swap meets with my grandfather isles of parts and shit everywhere man, and you haggled over every dollar spent.

Thanks for the review this is exactly what I’m looking for canned tuna of the highest quality and not scraps but full fillets/ steaks. You recommend raincoat however where can I get it for a decent price in the US?

At last! ... Somebody who speaks english the same freakin way I do! ... Great video!

I used foam insulation board and going strong 3 years. Sand is so messy. Plus the family likes the way the foam board feels underfoot. And these pool types, the supports legs are meant to go straight on the ground. And if putting anything under to support the legs it should be flush to the ground and away from the liner. I know this is an older video and hope all is well this swim season for you ❤

A day to fill it up lol. More like 3 hours i have same one

Hey partner, I got one too. Don't forget to protect them ears.

I like the build quality and brightness of the Icon better, but the replaceable battery and full swivel on the Braun is really nice. Wish they could combine the strengths of both into one.

Excellent review

Holy crap, dude... FOCUS. You keep getting distracted. this vid should have been no longer than 2 minutes!

Great video. Why were you replacing the switch and how did you get to that conclusion? I have a failed wiper and so far, motor is good, fuse if good, wiper switch is good, if i turn the ignition off and on pull the wiper plug, engage the wiper stalk plug the wiper motor it responds a little!? I am ordering a power probe tool to see if i can find a short is my only theory at this point!?

Minka...had 3 seperate replacement fans sent over 2 years. 4 seperate receivers. All died. Extremely poor quality control and obviously faulty design. Really good looking and effective when working. Do not buy unless you enjoy frustration.

termites

Idk but the instruction manual does say to put it up on what looks like pavers

I like the idea using that broom thing to smooth it out ...will be doing that when mine arrives

Thanks for this. Just finished trading out mine with the Amazon model you linked too. EPC and Check Engine light were on, and it was in a bit of a limp mode with limited power above 2,000rpm. After changing, first start didn't work but on the 2nd try it fired right up. EPC light went out, but CE light is still hanging around. I'm guessing that it'll clear after a few more run cycles. The re-learn procedure in the comment from THXFXR didn't seem to do anything for me - I never got a 'Bing'. I don't know if it made any difference, but removed the negative cable from my battery while i did the work. Hardest part for me was removing the engine cover (gloves help with this) and dealing with the fuel supply line. Everything else was relatively easy, and I'm not a particularly skilled, experienced or equipped car mechanic. I took my time and was very careful to avoid dropping any fasteners or tools. Torx T20 bits got the airbox parts off and a T30 got the throttle body off. You'll want a couple of different nut driver options as mine was a little too long for a couple of screws. Fortunately I was able to improvise. I'd suggest maybe swapping spark plugs out while you're doing this since you'll have the engine cover off anyway. That was pretty darn easy and only took an extra 10-15 minutes.

Oh la vache merci beaucoup !!! Depuis 7 ans que je l’ai je trouvais dommage de m’en séparer. Sauf que maintenant elle bug sur « impression page d’alignement » 😢 peut être est-ce la fin pour elle ?

Wow!

Got a heck of a deal on a lightly used gt2100 a couple of weeks back, and today it came back with the steering tilt broken after I let my kids drive it. This video is very helpful, thank you.

Do you find that the lifeproof fits more flush than traffic master. Im using traffic master and not really liking how they fit into each other

looks like you cut that slit in that strategic spot to make a video about your perceived aggrievement what a baby

God bless keep up good work

I can't see the product name

Do you have all links to add the new filter?

Random n coast must be double cooked and the reason there is less natural in there. It was cooked out the first cook

They only contain tuna, no liquids added

Always add water first,with the mixer running

they work great but dangerous, Just ripped into my calf with it and been to 2 ERs as it is a bad tool to get cut up with

Ya burn through string in seconds. Dont buy it folks.